Owner's Manual

Programmer
118
Chapter 3 Programming with Command Function
Rotating a pattern clockwise (counterclockwise)
Command to be used
M
6
6 6
Rotating clockwise.
M
6
6 7
Rotating counterclockwise.
This function is available only when the needle is at the home position.
Values of 1 - 359 degrees are available for input.
The reference point of rotation is the center of the external shape of the data.
1. Make sure that the needle is at the home position.
Press
R
if the needle is not at the home position.
2. Input
M
6
6 6
or
M
6
6 7
.
3. Input the angle in 3 digits, then press
L
.