Owner's Manual

Programmer
117
Chapter 3 Programming with Command Function
Offset
Command to be used
M
4
Creating offset. Input the width of offset in .
Values 1.0 - 9.9 mm are available for the width
Example Width Input
1.5 mm 415
M
5
Offsetting the data to the right side of the sewing path. Input
the width to be offset in .
M
Input the stitch length in .
Moving to stitches ahead.
Moving to stitches back.
It will automatically become the first point to be offset.
1. Move the needle to the first point to be offset.
2. Determine the stitch width, then input
M
4
or
M
5
.
To change the stitch length, input it after this procedure.
3. Move to the last point to be offset.
4. Press
L
twice.
Displays the number of the command input.
Stitch count to be moved
Stitch count to be moved