Owner's Manual

Programmer
116
Chapter 3 Programming with Command Function
Editing data
Changing stitch length of the program
Command to be used
1
1 1
M
Changing the stitch length of the program
This function is available only when the needle is at the standby position.
The pitch of the needle tacking data is not changed. The following settings of attributes
become invalid when changing the pitch. Set them again after changing the pitch.
* Two step tension setting
* Two row switch
* Option output
* Slow conversion
1. Check to see that the needle at in the standby position.
Press
R
if it is not at the standby position.
2. Input
1
1 1
M
.
3. Input the stitch length in 3 digits, then press
L
.
Displays the number of the command input.
Stitch length