Owner's Manual

Programmer
113
Chapter 3 Programming with Command Function
Displays the number of the command input.
Indicates when it is set.
Displays the number of the command input.
Indicates when it is set.
Setting needle tacking in a unit of one stitch
Command to be used
L
3
3 3
Setting needle tacking.
L
3
3
4
Canceling needle tacking.
1. Move to the desired needle position.
Refer to page 112 on how to move the needle position.
2. Input the command of needle tacking.
Setting two step tension output
Command to be used
L
3
3 3
Setting two step tension output.
L
3
3
4
Canceling two step tension output.
1. Move to the desired needle position.
Refer to page 112 on how to move the needle position.
2. Input the command of two step tension output.