Owner's Manual

Programmer
112
Chapter 3 Programming with Command Function
Checking attributes
Attributes in the current needle position are displayed on the programmer screen.
The needle position can be moved as follows.
* Check each stitch.
* Check a series of stitches automatically.
Checking each stitch
1. Press to move forward, to backward.
The needle steps by each stitch and the setting of the data is displayed.
Checking a series of stitches automatically
1. Input the stitch count to check.
2. Press
to move forward, to backward.
The needle moves by the input count and the setting of the data is displayed.
Input "999" to check all stitches.
This screen is displayed while the needle is moving.
This screen is displayed after the needle has stopped.