Owner's Manual

Programmer
109
Chapter 3 Programming with Command Function
Creating tacking data
Command to be used
9
LILI
Create needle tacking data. Input stitch length in .
Values 0.1 to 1.0 mm are available for the stitch length.
Tacking width of the needle is set with the dial
on the back of the top part of the machine.
Values 1.0 to 3.5 mm are available for the
tacking width.
1. Determine the sewing start position with , then press
L
.
2. Determine the stitch length, then input
9
LI
.
3. Move the needle with , then press
L
.
Displays the number of the command input.