Owner's Manual

Programmer
108
Chapter 3 Programming with Command Function
5. Repeat steps 3 and 4 and move the needle to the end point. Input
E
1
1 1
.
When the alarm sound is complete, the needle point moves to the end position.
Creating feed data
Create (feed) data of the needle to move the needle from the current position to the next
without dropping it.
Command to be used
F
L
7
7 7
Moving in parallel for the feed
1. Move to the point immediately preceding the point to be fed.
2. Press
F
.
3. Determine the feed point with , then press
L
.
Displays the number of the command input.