Owner's Manual

Programmer
106
Chapter 3 Programming with Command Function
Creating a curve
Command to be used
M
0
Input the stitch length in .
Example Pitch Input
0.5mm 005
3.0mm 030
L
7
8 9
This command represents completing creation of a curve.
Increase the number of plotting points to create a smoother curve.
One to 99 points are available for plotting.
1. Select the start point with , then press
L
.
2. Input the stitch length in 3 digits, then press
M
.
3. Move the needle with , then press
L
in the position to be
plotted.
4. Input
L
7
8 9
at the end position of the needle.
Displays the number of the command input.
Displays the number of the command input.