Owner's Manual

Programmer
104
Chapter 3 Programming with Command Function
2
Moving in parallel
1. Move the needle with . Press
L
when the needle point is at A of the pattern.
3
Saving
1. Specify the program number on the operation
panel, then press
switch for writing into the
floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.
4
Ending program
1. Press
P
.
Deleting a part of the program during programming
A program can be modified during programming. The
example in the left is used for explanation of deleting 2
stitches at 8 and creating a new program.
1. Press
ESCESC
in the position 8 to display the screen
on the right.
2. Input the number of stitches to be deleted, then
press
.
The example is deleting 2 stitches backward. Press
2
.
3. The needle point moves to 6.
4. Continue programming.