Owner's Manual

Chaprter 3 Programming with Command Function
Programmer
103
3
Deleting A
1. Press
C
.
2. Input the number of stitches to be deleted, then
press
.
The example is deleting 1 stitch. Press
1
.
3. The needle point moves to 1.
4
Saving
1. Specify the program number on the operation
panel, then press
switch for writing into the
floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.
5
Ending program
1. Press
P
.
Moving the entire pattern in parallel
The entire program data is moved in parallel. The
example in the left is used for explanation of moving the
program data in parallel.
1
Calling data
1. Specify the program number on the operation
panel, then press
switch to read the data.
Refer to "Using the operation panel of the main body"(page 128)
for detailed operation.
Standby position
Standby position