Owner's Manual

42
Chapter 8 DEVICES
BAS-364E, 366E, 370E, 375E
4. Stepping foot control mechanism
●
If the thickness of the material being sewn changes
when sewing one pattern, an intermittent presser foot
height can be selected without interrupting sewing.
●
Use the programmer to program the intermittent presser
foot height.
●
The height of the intermittent presser foot can be
changed in 0.5 mm or 1 mm increments. Operate the
panel and change the memory switch setting to select
the desired mode.
3. Two-stage thread tension mechanism (Option)
●
This mechanism is used to enable selection of the
thread tension in two steps when sewing a single
pattern.
●
It is useful when a different sewing tension is necessary
while sewing a single pattern due to the sewing direction
or differences in the material.
●
Use the programmer to program the different needle
thread tensions in two steps.
●
The two-stage thread tension mechanism can be set
to operate or not operate by means of the memory
switch.
Two-stage
thread tension
mechanism
Stepping foot
control mechanism