Owner's Manual

BAS-364E, 366E, 370E, 375E

Chapter 5 OPERATING PROCEDURE

3. Using the program R/W (Read/Write) switch

Programmed stitch patterns stored on floppy disk can be read into memory, and newly programmed pat terns can be

written to disk for permanent storage and later recall.

Insert the floppy disk q containing or which is to contain

the programmed stitch pattern.

Press the program select switch e on the operation panel.

The program number will then appear in the PROGRAM

NO. display w. After selecting the desired program num-

ber, press the R/W switch r. The disk drive indicator t

will illuminate and a "P" will appear on the PROGRAM

NO. display w to indicate that the data is being read. When

the alarm sounds and the disk drive indicator t turns off,

the program number will then flash in the PROGRAM NO.

display w instead of the "P" to indicate that the reading of

the data is complete.

Press the program select switch e on the operation panel

to select the desired program number. After programming

the pattern using the stitch programmer, press the R/W

switch r. The disk drive indicator t will illuminate and a

"P." will appear on the PROGRAM NO. display w to indi-

cate that the data is being written. When the alarm sounds

and the disk drive indicator t turns off, the program num-

ber will then flash in the PROGRAM NO. display w in-

stead of the "P" to indicate that the writing of the data is

complete.

If an error code is displayed in the display w, and alarm

will sound.

Press the reset switch y on the front of the machine to

stop sewing machine operation, and then refer to and fol-

low “Chapter 12 ERROR CODE”.

To READ a pattern to memory

To WRITE a pattern to disk

If an error code is displayed