Owner's Manual

53
BAS-364E, 366E, 370E, 375E
Chapter 11 CHANGING SPECIAL FUNCTIONS AND USING THE MEMORY SWITCHES
SW. No.
memo-00
memo-01
memo-02
memo-03
memo-04
memo-05
memo-06
memo-07
memo-08
memo-09
memo-0A
memo-0b
memo-0c
memo-0d
memo-0E
memo-0F
When “on”
Feed plate moves in the order X → Y when moving to the home position, and moves in the order
Y → X when moving to the sewing start position.
Feed plate moves in the order Y → X when moving to the home position, and moves in the order
X → Y when moving to the sewing start position.
Feed plate moves in the order forward X → Y when moving to the home position, and moves in
the order forward X →Y when moving to the sewing start position.
Eject device operates.
If DIP switch A-7 is also ON, eject is on standby so that sewing starts automatically.
-
-
-
-
-
-
-
Set to “on” when using the 2-step tension device.
-
-
-
-
■ Memory switches [00] - [0F]
SW. No.
memo-10
memo-11
memo-12
memo-13
memo-14
memo-15
memo-16
memo-17
memo-18
memo-19
memo-1A
memo-1b
memo-1c
memo-1d
memo-1E
memo-1F
When “on”
-
Lower thread counter and production counter are updated each time thread is trimmed.
Upper thread presser operates.
Presser foot controller operates at 0.5 - mm intervals.
Needle up errors are not detected.
-
-
Bottom plunger operates.
Jig recognition device operates.
-
-
-
Lower thread counter is decremented at the sewing start.
-
-
-
■ Memory switches [10] - [1F]