Owner's Manual

45
BAS-364E, 366E, 370E, 375E
Chapter 8 DEVICES
Selecting sub-work clamp operation
Note
Always be sure to turn off the power when changing the DIP switch settings.
●
After sewing, the standard work clamp q, presser foot w and sub clamp e are raised simultaneously, but they are
lowered separately as shown below. The movement can be changed by means of a DIP switch. (The work clamp lift
switch r is a two-stage switch.)
●
When DIP switch A-2 is OFF
* When the first-stage switch is ON, work clamp q, stepping foot w and sub clamp e are lowered.
●
When DIP switch A-2 is ON
* When the first-stage switch is ON, the work clamp q and stepping foot w are lowered. Then, when the second-
stage switch is ON, the sub clamp e is lowered.
8. Sub clamp (BAS-370E, 375E only)
This is used when the standard clamp alone cannot hold the work piece properly.
When using the sub clamp, set DIP switch E-2 on the main circuit board.
12345678
12345678
A
B
r
q
w
e
First-stage
Second-stage
B’
C
D
E
Main circuit
board