Owner's Manual

Chapter 3 INSTALLATION

BAS-364E, 366E, 370E, 375E

3. Installing the needle plates

1. Loosen the bolts q, and then pull the needle plate support bases w to the outside.

2. Secure the needle plate support bases w by tightening the bolts q and the bolts e.

3. Install the needle plate support brackets r to the needle plate support bases w by tightening the bolts t from

below.

* For the BAS-366E and BAS-375E, install the needle plate support brackets y to the needle plate support brackets

r with the bolts u.

4. Place the screw holes in the left needle plate i, center needle plate o and right needle plate !0 on top of the

needle plate support hases w so that the screw holes are aligned, and then secure them by tightening the screws.

* For the BAS-364E, install the center needle plate !1 only.

* For BAS-370E, 375E

* For BAS-364E, 366E

!0oi