Software User's Guide
Table Of Contents
- SOFTWARE USER’S GUIDE Label Printer TD-series
- Introduction
- Table of Contents
- 1 Installing and Uninstalling P-touch Editor and P-touch Update Software
- 2 Customizing Labels
- 3 Creating Labels
- 4 How to Use P-touch Editor
- 5 How to use P-touch Transfer Manager & P-touch Library
- Using P-touch Transfer Manager
- Transferring the label template to P-touch Transfer Manager
- Starting P-touch Transfer Manager
- Transferring templates or other data from the computer to the printer via USB
- Transfer the templates to the printer via network (TD-2120N/2130N/4100N only)
- Backing up templates or other data saved in the printer
- Deleting all the printer data
- Using P-touch Library
- Using P-touch Transfer Manager
- 6 Transferring label templates with P-touch Transfer Express
- Preparing P-touch Transfer Express
- Transferring the label template to P-touch Transfer Manager
- Saving the label template as a Transfer Package file (.pdz)
- Distributing the Transfer Package file (.pdz) and P-touch Transfer Express to the user
- Transferring the Transfer Package file (.pdz) to Brother printer
- 7 Printing the list of label templates
- 8 Printing labels using P-touch Template
- 9 Updating P-touch Editor (all models) / Updating the Firmware (TD-2020/2120N/2130N only)
- 10 Printing labels distributed to multiple printers
- Appendix
- brother US ENG
Printing labels using P-touch Template
73
8
2 Refer to the example below, and scan the barcode for the number specified as the key number.
Example for key number 5:
Select template
3 Scan the “Number of serialized copies” barcode.
4 Specify the number of copies to be printed.
Refer to “For entering numbers” on page 88, and scan the barcodes for the three digits of the
number of copies to be printed.
Example for 5 copies:
5 Scan the “Begin printing” barcode, shown below.
For this example, labels with the numbers 1234567890 to 1234567894 will be printed.
NOTE
• The Numbering field will increase by 1 with each label that is printed.
• The count will be stored in the printer, even if it is turned off.
• To reset the count to the original number, scan the “Initialize template data” barcode, shown below.
^TS005
^NN
005
^ID