Quick Setup Guide (Touch Panel Display)
Table Of Contents
- Quick Setup Guide PA-TDU-001
- Safety Precautions
- Symbols Used in This Document
- Regulation
- Printing With the Touch Panel Display
- General Description
- Attaching the Touch Panel Display
- LCD
- Touch Panel
- Touch Panel Display Settings
- Creating a Label Layout
- Transferring the Label Layout to the Printer
- Printing the Label
- Label Layouts on the Printer (Checking, Deleting and Log)
- Frequently Asked Questions
- Product Specifications
- Panel Figure (Actual Size)
- brother ENG
6
d While holding the RD Roll compartment
top cover securely, use a screwdriver to
remove the four screws (1).
e Close the RD Roll compartment top
cover, and then remove the top cover
(1).
f Plug the connector on the touch panel
display into the connector on the printer.
Insert the four tabs on the touch panel
display into place on the printer.
Be careful not to allow the top cover to
fall when the four screws are removed.
1
1
Be careful that the connector cords are
not trapped by the cover. In addition, if
the cords are caught between the screw
holes, the cords may be damaged when
the screws are tightened.