Owner's Manual

Programmer
50
Chapter 2 Programming with Help Function
2. Select with and press .
3. Move the work clamp with
. Press
when the needle point is at point q of
the pattern.
The first stitch (point q) is programmed.
4. Select with and press .
5. Input the stitch length and the number of
lines for a multiple stitch. Press
.
"2.0 mm" is input for a stitch length in the example.
Input "030" to make the stitch length to 3.0 mm.
To switch input between the stitch length and the number of
lines, use .
6. Move the work clamp with . Press
when the needle point is at point w of
the pattern.
7. Move the work clamp with
. Press
twice when the needle point is at point e
of the pattern.
Be sure to press twice for a split at a corner like point e. If
a split is not made, the corner will be round.
8. Program the following points up to point !7
with the curve programming steps.
When there is a liner section, move the needle point from the
split to the next split, and press twice.
In the example, a linear line is programmed between points u
and o. Be sure to program a linear line also for the matched
section between points @4 and @6.
By pressing
0
, the needle point is returned to the previous
point. It cannot be returned beyond the previous split.
By pressing
1
, the needle point is returned to the previous
split. However, when the needle point is at a split, it cannot be
moved.
By pressing
2
, the needle point is returned to the split
before the previous split.
9. Press
F
. Move the work clamp with
. Press when the needle point
is at point !8 of the pattern.