Owner's Manual

Programmer
32
Chapter 2 Programming with Help Function
5. Input the stitch length and press .
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
6. Move the work clamp with . Press
when the needle point is at point B of the
pattern.
7. Repeat step 6 and create the program to
point C.
8. When point C is programmed, press
again.
Point C becomes a corner and is programmed. To change the
stitch length, press

ESCESC
for resetting.
9. Create the program to point E.
10. When point E is programmed, press
again.
11. Create the program to point I.
12. When point I is programmed, press
again.
13. Press

ESCESC
twice.
2
Inputting the end code
1. Select with and press .
2. Select the end code type with
and
press
.
"111" is selected in the example. Press and the work clamp
returns to the first stitch (point A) .
3. Press

ESCESC
.
The work clamp returns to the home position.