Owner's Manual

Programmer
126
Chapter 3 Programming with Command Function
4
Ending program
1. Press
P
.
Resizing input
Resizing input is used to program a detailed pattern
stitch by stitch. The example in the left is used for
explanation of programming the pattern to the
magnification of 5.
1
Programming
1. Press
P
.
The work clamp moves to the home position and the
programmer screen is displayed.
2. Press
M
9
0 5
.
9
is the command for resizing input. Input the
magnification (02, 05, 10) in
.
3. Move the work clamp with . Press
L
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
4. Repeat step 3 and create the program to
point D.
2
Inputting the end code
1. Press
L
at the last stitch and press
E
1
1 1
.
The work clamp returns to the start position.
3
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.