Owner's Manual
11. Changing special functions using the memory switches
49
BAS-343E
Explanation
Time until feed mechanism starts moving after work clamp has lifted.
Changes the feed speed.
1 (Fast) 4 (Slow)
Changes the possible sewing speed for a given stitch length.
1 (Fast) 7 (Slow)
1 (2,700/3 mm), 2 (2,600/3 mm), 3 (2,500/3 mm),
4 (2,300/3 mm), 5 (2,000/3 mm), 6 (1,800/3 mm),
7 (1,200/3 mm)
Settings 1 and 2 are outside the warranty specification
at the time of shipment from the factory.)
Changes the feed timing
1 (Fast) 5 (standard) 10(Slow)
Number of low-speed stitches sewn at 400 spm at sewing start
Solenoid ON time changes when work clamp is being lowered
(solenoid specifications only)
10 60
(Quiet) (High work clamp capacity)
The solenoid ON time when the presser foot is raised
changes.
(Standard) 1 3 (Upper limit)
Specifies the enlargement and reduction method when
reading from a 2DD floppy disk.
0: No conversion; 1: 311, 311A; 2: 326, 326A, 326L,
326LA; 3: 341, 341A, 342, 342A
Delay time from the point when the cassette is clamped
to the start of sewing when DIP switch A7 is ON during
automatic sewing
Sets the enlargement and reduction home positions on
the panel.
SW No.
memo-30
memo-31
memo-32
memo-33
memo-34
memo-35
memo-36
memo-37
memo-38
memo-39
memo-3A
memo-3b
memo-3c
memo-3d
memo-3E
Possible
setting range
1999
14
17
110
15
1060
13
03
120
011
Units
10ms
x 7.5
ms
0.1s
Initial
value
10
1
3
5
0
40
1
0
1
0
0
0
0
0
0
■ Turn the dial while pressing the STEP BACK switch to change the values.