Owner's Manual

10. DIP switch
43
BAS-343E
■ DIP switch A
SW No.
A - 5
A - 6
A - 7
A - 8
When ON
After sewing is completed, work clamp does not automatically rise (only in split mode)
Clamping force output is produced (Inner clamping device available as an option)
After the cassette is clamped automatically, sewing operations start automatically.
Thread breakage detector device is activated (available as an option)
■ DIP switch B
SW No.
B - 1
B - 2
B - 3
B - 4
B - 5
B - 6
B - 7
B - 8
When ON
Single split mode activated
−
Thread is not trimmed after an emergency stop
Needle cooler output is produced.
When a rotating-type thread breakage detector device is used, detection precision is increased from 8 to 14.
When a fiber-type thread breakage detector device is used, detection precision is increased from 5 to 10.
Fiber-type thread breakage detector device is ON, and DIP switch A - 8 is ON (available as an option).
When using a 3-stage pedal
Feeding speed is switched to high speed.