Owner's Manual

9. Standard adjustments
40
BAS-343E
9-13. Checking the input sensor and DIP switch input
1. When the SPLIT NO. indicator q is illuminated and the R/W switch e is pressed while the TEST switch w is being
pressed, the X-SCALE indicator r will illuminate and the state of the X home position signal will appear on the
display screen t.
■ When sensor is ON
■ When sensor is OFF
2. Each time the MENU switch y is pressed, a different indicator will illuminate and the operating condition for the
corresponding item will appear on the display screen.
• When X-SCALE indicator is illuminated : X home position sensor
• When Y-SCALE indicator is illuminated : Y home position sensor
• When SPEED indicator is illuminated : Needle up signal (synchronizer)
• When B.T. COUNTER indicator is illuminated : 24-section signal (synchronizer)
• When SPLIT ON. indicator is illuminated : Needle down signal (synchronizer)
3. If the settings for DIP switch A at the side of the operation panel are changed at this time, the number of the
changed switch will appear in the top row of the program number display u.
4. If the settings for DIP switch B are changed at this time, the number of the changed switch will appear in the
bottom row of the program number display u.
プログラプログラムNO.
PROGRAM NO.PROGRAM NO.
メニュー
MENU
下糸カウンタ ー 
B.T. COUNTER
スプリット NＯ.
SPLIT NＯ.
横倍率
X
-
SCALE
縦倍率
Y
-
SCALE
スピ ー ド
SPEED
読/書
R / W
BAS-300E series
電 源

POWER
テスト
TEST
ステッテップバック

STEP BACK

下糸設定
B
. T. SET
下糸交換
B.B.T. CHANGE. CHANGE
w\y\
e
u
t
r
q

A
B
OFF
OFF

