Owner's Manual

7. Sewing

BAS-343E

7. Sewing

7-1. Before starting sewing....

Check that the needle bar is at the highest position. Turn

the machine pulley so that the index mark q on the pul-

ley is almost aligned with the point where belt cover U

and belt cover D meet.

* If the machine is started while the index mark q is not

correctly aligned, error message "E-22" will be dis-

played (only when memory switch No.14 is on).

7-2. Sewing operation

1. Turn the power switch q on.

(The power indicator on the operation panel will light.)

2. Insert the floppy disk w.

3. Press the PRO. No. selection switch e to select the

desired program number.

4. Press R/W switch r.

The floppy disk drive indicator will light and the pro-

gram no. display t will show a P while the data is

being read. When reading is completed, an alarm will

sound and the indicator will go out, then the program

no. display t will blink the program number.

Turn off the power switch at the following times, otherwise the machine may operate if the foot switch

is depressed by mistake, which could result in injury.

• Threading

• When replacing the bobbin and needle

• When not using the machine and when leaving the machine unattended

Do not touch any of the moving parts or press any objects against the machine while sewing, as this

may result in personal injury or damage to be machine.

CAUTION

プログラプログラムNO.NO.



PROGRAM NO.

読/書

R / W