Service manual

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY

4-56

(10) Remove the two pan (washer) M2.6x6 Taptite screws.

(11) Remove the heat roller 25.

(12) Remove the halogen lamp.

Fig. 4-99

NOTE:

When re-assembling the halogen heater lamp, ensure that the direction of the halogen heater

lamp is correct referring to the figure above.

CAUTION:

• Never touch the surface of the halogen heater lamp.

• When securing the screw to assemble the halogen lamp connector plate, ensure you use

the Fu lamp assembly jig ASSY as shown in the figure below to avoid damaging the edge of

the halogen heater lamp.

Fig. 4-100

Screw, pan (washer) M2.6x6

Fu lamp assembly jig ASSY

Halogen lamp connector plate

Halogen heater lamp

Screw, pan

(washer) M2.6x6

Heat roller 25

FU frame upper

Heat roller 25

Halogen lamp

connector plate

Screw, pan (washer)

M2.6x6

Halogen lamp

Colored side

115V:Orange

230V:Black