Owner's Manual

139
Arranging Embroidery Designs (Layout & Editing)
Arranging Embroidery Designs (Layout & Editing)
■ Writing an embroidery design to
an original card
You can save a displayed embroidery design onto
an original card in order to transfer it to a embroidery
machine.
Toolbar button:
1. Insert an original card into the USB card writer
module.
c
“Transferring the design to an original
card” on page 17.
2. Click , or click File, then Write to Card.
→ The following message appears.
b Memo:
For details on writing two or more files to an
original card, refer to “Writing Embroidery
Design Files to an Original Card” on page 194
in the Instruction Manual (PDF format).
a Note:
Be sure that the hoop size of the design does
not exceed the hoop that will be used on the
embroidering machine.
a Note:
When writing to an original card that already
contains data, all data on the card will be
deleted. Before writing to a card, save all
necessary data to a hard disk or other
media, and check that no necessary data
remains on the card.
c
“From an embroidery card” on
page 49.
b Memo:
Designs created on a custom-sized Design Page
are written to cards split into their various
sections.
If the total size of the design exceeds the capacity
of the original card or if your Design Page is set to
a custom size of 90
× 90 cm (35.4” × 35.4”), and
is split into over 80 sections, you will need to split
the design into sections and write them onto
several original cards.
In this case, the
Select Hoop Sections dialog
box appears to let you select the sections that can
be written in the available space on the card.
The progress bar at the top of the dialog box
shows the available space on the card as you
select design sections to be written to the card.
The space used by the selected design sections
appears in blue. If you select several pattern
sections which exceed the size limit, the space
used appears in red.
Click each design section to select it, and then
click Write to write the selected design
sections to the card. To deselect a design
section, simply click it again. (The
Write
button is available only when a section is
selected and the space on the card is
sufficient to receive the selected design.)