All in One Printer User Manual
Table Of Contents
- NETWORK USER'S GUIDE
- Definitions of warnings, cautions, and notes
- Trademarks
- Compilation and publication notice
- IMPORTANT NOTE:
- Table of Contents
- 1 Internet FAX
- Overview
- 2 Windows® Internet printing
- Internet Printing Installation
- Overview
- Brother Internet Print General Information
- Brother Internet Print: Configuring the Brother Print Server
- Brother Internet Print: Using the BRAdmin Professional utility to Configure the Print Server
- Brother Internet Print: Installing the BIP software on Windows® 98/98SE/Me/2000/XP/XP Professional x64 Edition
- Adding a Second Brother Internet Port
- Other sources of information
- Internet Printing Installation
- 3 Control panel setup
- A Appendix A
- B Index
Internet FAX
4
1
If the PC to which you wish to send a document is not running Windows
®
98/98SE/Me/2000/XP/XP
Professional x64 Edition operating system, please inform the PC's owner that they must install some software
that can view TIFF-F files.
You can use “Microsoft
®
Imaging” that is supplied with Windows® 98/Me/2000 and Windows “Picture and
Fax Viewer” with WIndows XP/XP Professional x64 Edition.
Forwarding Received E-mail and Fax Messages 1
You can forward received E-mail or standard fax messages to another E-mail address or fax machine.
Received messages can be forwarded via E-mail to a PC or Internet Fax. They can also be forwarded via
standard phone lines to another machine.
The setting can be enabled through the the machine’s control panel. The steps for configuring Fax Forward
can be found in the User’s Guide supplied with your machine.
Please see the User’s Guide included with the machine to check that this feature is supported.
TX Verification Mail 1
Transmission Verification Mail supports two separate functions. Verification Mail for sending allows you
request notification from the receiving station that the I-Fax or E-mail was received and processed.
Verification Mail for receiving allows you to transmit a default report back to the sending station after
successfully receiving and processing an I-Fax or E-mail.
To use this feature you must set the Notification option within the Setup Mail RX and Setup Mail TX
options.
Setup Mail (TX) 1
You can set the Notification option in the Setup Mail TX option to either ON or OFF. When switched to ON
an additional field of information is sent with the image data. This field is named MDN (See
Notification on page 23).
MDN
1
Mail Disposition Notification - This field requests the status of the I-Fax / E-mail message after delivery
through the SMTP (Simple Mail Transfer Protocol) transport system. Once the message has arrived at the
Receiving station this data is used when the machine or user reads or prints the received I-Fax or E-mail. For
example, if the message is opened for reading or is printed the receiving station sends back a notification to
the original sending machine or user.
The receiving station must support the MDN field in order to be able to send a notification report, otherwise
the request will be ignored.