Operation Manual
Table Of Contents
- Terms of Use
- INTRODUCTION
- IMPORTANT NOTICE
- IMPORTANT SAFETY INSTRUCTIONS
- FEATURES
- Chapter 1 GETTING STARTED
- Chapter 2 BASIC OPERATIONS
- Chapter 3 ADVANCED OPERATIONS
- CUTTING AND EDITING FUNCTIONS
- Pattern Editing Functions
- Pattern Editing Functions - Multiple Patterns
- Mat Layout Screen
- Layout Editing Functions
- Object Editing Screen
- Undoing an Operation
- Grouping/Ungrouping Patterns
- Welding (Merging the Outlines of Multiple Patterns)
- Aligning Patterns
- Auto Layout Functions
- Scanning a Background Image
- Character Input Functions
- MEMORY FUNCTIONS
- Retrieving Embroidery Data for Cutting (Compatible Models Only)
- DRAWING FUNCTIONS
- CUTTING AND EDITING FUNCTIONS
- Chapter 4 SCANNING FUNCTIONS
- Chapter 5 APPENDIX
- INDEX
29
2
b Touch or to adjust the cutting
pressure, and then touch the "OK" key.
c Check that the settings have changed in the test
screen, and then perform test/trial cut again.
Note
• Be careful not to increase the pressure too
much. Otherwise, the blade may break. If the
pressure is too strong, the material may not be
cut cleanly. In addition, the mat will deteriorate
more quickly.
■ Half Cut (Kiss Cut) Settings
To make half cuts (kiss cuts), turn on half cut (kiss cut) in
the settings screen before beginning to cut.
a Touch in the preview screen to display the
settings screen.
b Turn on “Half Cut”, and then touch the “OK”
key.
• The pressure for half cut (kiss cut) can adjusted
with “Cut Pressure (Half Cut)”. Adjust the cutting
pressure until half cut (kiss cut) result is as desired.