Instruction Manual for Rotary Auto Blade Kit

8
Note
• Before changing the layout, be sure to touch in the auto layout screen and make sure that the pattern interval is set
to “5”.
k Insert a pen into the pen holder, and then install the pen holder in the machine.
Note
• Before starting to draw, make sure that the scanner lever (on the left side of the machine) is set to “2”.
l Select “Draw” in the preview screen, and then touch the “Start” key to draw the seam allowances and match
marks.
 When drawing is finished, the preview screen appears.
m Remove the pen holder, and then install the rotary auto blade holder.
Note
• Before starting to cut, make sure that the scanner lever (on the left side of the machine) is set to “1”.
n Select “Cut” in the preview screen, and then touch the “Start” key.
 Repeat the procedure from step d to cut out all parts for the project. When cutting is finished, refer to the recipe book to
complete the project.