Instruction Manual for Roll Feeder

35
Non-Compatible Material
The following material cannot be used, even if it has backing paper or backing film. The material may separate and cause jamming
during cutting.
■ Material whose end curls upward when the roll is loaded with the backing paper or backing film
facing down
Be sure to check this when using iron-on transfer material.
If the end of the material curls upward, cut it to the appropriate size, and then attach it to a mat.
 Otherwise, the material may become jammed in the machine.
Note
• If the rolled iron-on material is 610 mm (24") long or shorter,
we recommend you use our 12" × 24" (305 mm × 610 mm)
optional cutting mat.
• If the rolled material is longer than 610 mm (24"), cut into 610
mm (24") long or shorter, then use our 12" × 24" (305 mm ×
610 mm) optional cutting mat.
When the end of the material curls
upward, it will not feed correctly.
a Rolled with the backing paper (backing film) on the outside
When the end of the material is flat or
curls downward, it will feed correctly.
a Rolled with the backing paper (backing film) on the inside
1
1
■ Material whose left and right edges are not parallel
● Left and right edges are not parallel. While the material feeds, it loses contact with a feed roller,
causing the material to become skewed and feed incorrectly.
● Left and right edges are parallel. The material feeds correctly.