Instruction Manual for Roll Feeder
Table Of Contents
29
Cutting
* For details, refer to the Operation Manual for the cutting machine.
Trimmer blade
Symptom Possible cause (or result) Solution Reference
The material being cut catches
on the tip of the blade.
Lint or dust has accumulated in the holder. Clean the holder.
*
The blade is worn. Replace the blade with a new one.
*
The material being cut is incompatible with
this machine.
Replace the material with one compatible with
this machine.
page 33
page 34
The machine stopped while an
operation is being performed.
For safety, the machine stops operating if a
button in the operation panel is pressed
while cutting.
Follow the instructions in the message that
appears in the screen. Touch the “OK” key to
move the carriage to its initial position. Insert the
material and perform the operation again.
—
Not all of the material to be cut
is cut. Some areas remain
uncut.
A blade incompatible with the material is
being used.
Replace the blade with one compatible with the
material.
*
If cutting is not possible even though the
cutting pressure is set higher than
necessary, the blade may be chipped.
Replace the blade with a new one.
*
The blade is worn. Replace the blade with a new one.
*
The material is incompatible with this
machine.
Replace the material with one compatible with
this machine.
page 33
page 34
The cutting pressure (“Cut Pressure (Half
Cut)”) is incorrect.
Adjust the setting for “Cut Pressure (Half Cut)” in
the settings screen.
page 19
Lint or dust has accumulated in the holder. Clean the holder.
*
There are deep cuts completely
through the backing paper of
the material.
The cutting pressure (“Cut Pressure (Half
Cut)”) is incorrect.
Adjust the setting for “Cut Pressure (Half Cut)” in
the settings screen.
page 19
The material cannot be cleanly
cut.
If the blade penetrates the material, faint cut
marks may remain on the machine's surface
where the blade makes contact (
1
).
Contact Brother Customer Service or Brother
authorized service center.
—
a
Symptom Possible cause (or result) Solution Reference
The material is not being cleanly
cut by the trimmer blade.
Before starting to cut, the material and
trimmer were not firmly pressed down with
your hand.
Firmly press down the material and trimmer with
your hand, and then start cutting.
page 13
page 17
Lint or dust has accumulated in the trimmer
blade.
Clean the trimmer blade.
page 27
The trimmer blade is worn. Replace the trimmer blade with a new one.
page 25
The trimmer blade has been
removed from the trimmer.
The trimmer blade was slid past the stopper
on the trimmer.
Follow the installation instructions to install the
trimmer blade.
page 26