Instruction Manual for Roll Feeder

12
a Pull the end of the material until it reaches the guide
channel.
• Check that the side to be cut faces up.
a Guide channel
b Material
b Make sure the left edge of the material is aligned with the
rolled material guide and the end of the material is
perfectly aligned with the guide channel.
● When aligned
The end of the material is perfectly aligned. There is no need to
evenly trim the end of the material.
a Rolled material guide
b Guide channel
c Material
 Feed the material into the machine. For details, see “Feeding
the Material” on page 14.
● When not aligned
The end of the material is not perfectly aligned. The end of the
material must be evenly trimmed.
a Rolled material guide
b Guide channel
c Material
 For details, see “Evenly Trimming the End of the Material” on
page 12.
Evenly Trimming the End of the Material
a Pull the end of the material until it extends past the guide
channel.
a Guide channel
b Remove the trimmer from the roll holder.
a Trimmer
c Install the trimmer over the material.
Align the holes in the trimmer with the pins in the base attachment
as shown below.
a Hole in trimmer
b Pin on base attachment
d Align the left edge of the material with the rolled material
guide.
a Rolled material guide
12
2
1
3
2
1
3
1
1
2
2
1
1
1