Instruction Manual for Roll Feeder 2

35
*1
The application sheet (also called a transfer paper or retack sheet) is a low-tack sheet used for attaching the adhesive craft vinyl to
the target surface. Use this sheet together with adhesive craft vinyl.
*2
Use the scraper (CASCP1) or brayer (CABRY1) for attaching the application sheet and for transferring the adhesive craft vinyl
cutouts to the target surface. To purchase a scraper (CASCP1) or brayer (CABRY1), contact the retailer where this product was
purchased.
● Iron-On Transfer Material
Iron-on transfer material is used for heat transferring patterns onto fabric such as T-shirts and sweatshirts. The material consists of two
layers: a thermo-softening adhesive sheet and carrier sheet (paper or film). After using the cutting machine to cut out your pattern,
such as text or a logo, from only the thermo-softening adhesive sheet, attach the pattern to the target surface by pressing down on the
backing with a heat press or iron.
* Please refer to the manufacturer's instructions included with the iron-on transfer material.
Applying the Iron-On Transfer Material to the Surface
*1
First check that an iron-on transfer can be applied to the target surface.
*2
The heat transfer conditions (temperature, pressing time, etc.) differ depending on the material being used. Use the material
according to the manual included with it.
Transfer the cut-out patterns to the
application sheet so that they
remain correctly arranged.
After wiping the target surface
clean, attach the adhesive craft
vinyl cutouts with the application
sheet. (
*2
)
Finally, peel off only the application
sheet.
4
5
6
Create your pattern in
CanvasWorkspace.
Make sure that the pattern is
flipped to create a mirror image. For
details, refer to the Operation
Manual for the cutting machine.
Half-cut the desired pattern with
the cutting machine.
Peel off any excess, leaving only the pattern on the backing. (Weeding)
With the backing facing up, place
the sheet cut in step onto the
target surface such as fabric (
*1
).
Transfer the pattern with a heat
press or iron. (
*2
)
Peel off only the backing.
1
2
3
4
5
6
3