Instruction Manual for Roll Feeder 2

12
a Pull the end of the material until it reaches the guide
channel.
• Check that the side to be cut faces up.
a Guide channel
b Material
b Make sure the left edge of the material is aligned with the
rolled material guide and the end of the material is
perfectly aligned with the guide channel.
a Rolled material guide
b Guide channel
c Material
a Rolled material guide
b Guide channel
c Material
Evenly Trimming the End of the Material
a Pull the end of the material until it extends past the guide
channel.
a Guide channel
b Remove the trimmer from the roll holder.
a Trimmer
c Install the trimmer over the material.
Align the holes in the trimmer with the pins in the base attachment
as shown below.
a Hole in trimmer
b Pin on base attachment
d Align the left edge of the material with the rolled material
guide.
a Rolled material guide
● When aligned
The end of the material is perfectly aligned. There is
no need to evenly trim the end of the material.
 Proceed to the “Attaching the Leader Sheet to
the Material” procedure on page 14, attach the
leader sheet to the material, and place it on the
cutting machine.
● When not aligned
The end of the material is not perfectly aligned. The
end of the material must be evenly trimmed.
 For details, see “Evenly Trimming the End of the
Material” on page 12.
12
1
2
1
3
2
1
3
1
1
2
2
1
1
1