Instruction Manual for Rhinestone Starter Kit

5
e Touch on the pattern editing screen, and set Half Cut
to ON.
• Half Cut feature is only available auto-blade holder is installed.
f Touch the "Test" key, and cut a trial cutting pattern with
the Auto Blade (Black Holder).
g If the backing of the template sheet is cut, adjust the Cut
Pressure(Half Cut) to lower it.
hIf the trial cutting of the pattern was cut properly, touch
the "Start" key and cut the rhinestone pattern.
• The rollers may leave marks in the template sheet, but this
should not affect its quality.
i When the cutting of the rhinestone pattern is complete,
feed out the mat and peel off the template.
• Cut the template sheet along an outline slightly larger than the
pattern.
j Place the template sheet on a flat surface with the
backing down, and then quickly peel the template sheet
off horizontally.
 The template sheet cutouts remain attached to the backing.
• If all template sheet cutouts do not remain attached to the
backing, use a pointed object, such as an awl, to punch out
each rhinestone hole from the back of the template sheet.
• Do not punch out the holes from the front side, otherwise the
adhesive side may become attached to itself.
k With the shiny side facing up, place the backing board
inside the box of this kit.