Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
9
e Press to load the mat into the machine, and then touch to scan the background. Position the pattern so it does not
extend from the material.
• Scanning the background allows you to check the position of the pattern within the material. If the pattern extends out of the material, touch
the “Edit” key, and then adjust the position or size of the pattern. The pattern can also be moved by dragging it in the screen.
Memo
• Since the paper piercing mat is black, it may be difficult to see the pattern in the displayed background scan, depending on where the
material has been attached.
In this case, touch , and then select beside “Background” to make the background image lighter.
a Pattern
b Material scanned for the background
f Touch the “Edit” key, and then touch the “Object Edit” key to display the object editing screen.
g Touch in the object editing screen to add an offset line to the pattern.
If the pattern will not be cut out, it is not necessary to add an offset line. Continue to step i to convert the cutting data to dot data for paper
piercing (hole punching).
1
2