Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
6
For detailed instructions on using the cutting machine, refer to the Operation Manual supplied with it.
■ Precautions
● Only pierce paper with a thickness of 0.3 mm or less. Otherwise, the needle may break or be damaged.
a Peel off the protective sheet from the paper piercing mat, and then attach the material to the mat.
• Attach the material so it does not extend from the adhesive side of the paper piercing mat.
• The paper piercing mat is compatible with paper piercing (hole punching) and cutting.
b Pull out the rear tray.
Before using the machine, be sure to pull out the rear tray.
c Raise the scanner lever (on the left side of the machine) to “2”.
• Since the paper piercing mat is thick, the lever must be set to “2” in order for the mat to be fed correctly.
d Select the location of the pattern to be retrieved, and then select the desired pattern.
Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper
Piercing the Material