Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
5
Creating an Original Pattern
For this example, the offset line created inside the selected cutting data pattern will be converted to dot data for paper piercing (hole
punching), and then data combining the cutting data and the dot data will be created.
a Select the pattern to be pierced.
b Create an offset line inside (inward offset) the selected pattern.
• For details on editing in CanvasWorkspace, select [Online Video Tutorials...] from the [Help] menu.
• If the pattern will not be cut out, it is not necessary to add an offset line. Continue to step
c to convert the cutting data to dot data for paper
piercing (hole punching).
c Select the inner line created in step b, and then select [Pierce] below [Operation] in the control panel.
The selected cutting data is converted to dot data.
d If necessary, change the color and spacing of the dots.
e Save the pattern, or send it to the cutting machine.
• For details, see “Selecting an Activated Paper Piercing Pattern” on page 4.
a Dot data
b Cutting data
a Dot color
b Dot spacing
1
2
a
c
1
2