Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
17
The following table lists some of the messages that may appear while the machine is operating as well as their corresponding
solutions.
Perform the necessary operation according to the instructions in the message or the solution described here. If the problem persists,
contact Brother Customer Service or Brother authorized service center.
Cutting Machine Error Messages
CanvasWorkspace Error Messages
Error Messages
Error Message (Cutting Machine) Cause/Solution
This mat cannot be used.
This message appears when you try to perform an operation
incompatible with the paper piercing mat.
The paper piercing mat is compatible with “Pierce”, “Cut” and
“Draw”. Select one of these operations. (page 1)
To scan with paper piercing mat, shift the scanner lever to position
"2".
The scanner lever (on the left side of the machine) is set to “1”.
Set it to “2”. (page 8, page 6)
Scanner lever is set to position "1".
Shift the scanner lever to position "2".
Includes a pattern converted to dot line on the mat.
Cannot reconvert the pattern once you save the pattern.
After a dot data pattern for paper piercing (hole punching) has been
saved, it cannot be edited the next time that it is retrieved.
Editing functions, such as enlarging/reducing or adding an offset line,
cannot be used with the cutting data of a pattern grouped together
with dot data.
Error Messages (CanvasWorkspace) Cause/Solution
Please activate the piercing function. (E95001)
If the Paper Piercing function is not activated, dot data cannot be
opened. Activate the Paper Piercing function.
Operation not allowed. The selected objects include rhinestone data.
(E95002)
Rhinestone data cannot be converted to dot data.
Select data that does not contain rhinestone data, and then convert it
to dot data.
Unable to use the piercing data with the roll feeder function. Please
select an artboard size other than "Rolled Material" in the Artboard
Panel. (E95003)
This message appears when you try to save or transfer to a cutting
machine dot data for paper piercing (hole punching) in the data
format for the roll feeder.
Dot data cannot be used in the data format for the roll feeder. Select
a size other than [Rolled Material] in the [Artboard Size], and use the
paper piercing mat.