Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
16
If the machine stops operating correctly, check the following possible problems as well as the FAQ on the Brother Solutions Center
(http://s.brother/cfoag/) before requesting service. If the problem persists, contact Brother Customer Service or Brother authorized
service center. An asterisk (*) listed as a reference page indicates the Operation Manual for the cutting machine.
* For details, refer to the Operation Manual for the cutting machine.
TROUBLESHOOTING
Symptom Possible cause (or result) Solution Reference
The material cannot be cleanly
cut. (Besides the joint parts)
The blade is worn. Replace the blade with a new
one.
→*
The cutting pressure (“Cut
Pressure”) is incorrect.
Increase the “Cut Pressure” in
the settings screen.
→*
Material moves or peel off while
paper piercing.
The order of the procedure is
incorrect.
Make sure to cut the pattern first
and then perform paper piercing.
→page 7
The length of joint part
(“Perforation Length”) is not
appropriate for the design.
Set the length of joint part
(“Perforation Length”) to “Long”
in the settings screen.
→page 12