Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
14
For this example, a project will be created using a paper piercing pattern (activated in CanvasWorkspace) that is split into parts
together with paper piercing tools of different diameters.
The following four patterns split into parts are added to CanvasWorkspace after the Paper Piercing function is activated.
Selecting a Pattern and Transfer it to the Cutting Machine
a In the object panel, select (Piercing).
A list of paper piercing patterns appears.
b Select the desired pattern, and then drag it into the editing area.
• The selected pattern can also be added to the editing area by clicking the pattern in the list.
• Activated paper piercing patterns cannot be enlarged or reduced.
c Select the pattern, and then click [Ungroup] on the [Layer] menu.
• In order to perform paper piercing with each pattern part, the pattern must be ungrouped before being transferred to the cutting machine.
Patterns split into parts are ungrouped.
d Use the desired method from the [File] menu to transfer the pattern to the cutting machine.
• For details, see “Selecting an Activated Paper Piercing Pattern” on page 4.
[Example] Creating a Project with Two Tools of Different Diameters
a
b