Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
13
b Touch or to fine adjustment the length of the uncut part. Touch “OK” after setting change has specified.
* The default setting is “Medium”.
Memo
• You can also change the setting on the test cut setting screen (a) or “Piercing Setting” screen (b).
a
b
Cleaning the Paper Piercing Tools
After paper piercing (punching holes) for a long period of time, material on the adhesive side of the paper piercing mat will attach to
the needle tip of the paper piercing tool.
Since this may prevent holes to be punched correctly, periodically clean the needle tip.
● Paper piercing tools are consumables. If the tool cannot properly punch holes, even after its tip has been cleaned, the needle tip
may have broken off. In that case, replace the tool. It is not possible to replace only the needle.
a Remove the protective cap from the paper piercing tool.
b Using a commercially available brush, clean dust attached to the needle tip.
c Attach the protective cap to the paper piercing tool.
Paper Piercing result Solution
Can’t easily take off the pattern from the material.
Touch and change the setting to “Short”.
The pattern moves or peel off while paper piercing.
Touch and change the setting to “Long”.
Maintenance