Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
12
q Touch the “Start” key to perform test paper piercing. Check the results of test paper piercing, and then, if it is acceptable,
touch the “Start” key.
• If the material peels off while paper piercing, stop the operation and refer to “Changing the Perforation Length” on page 12 and increase the
joint part length by changing the “Perforation Length” (joint part) setting.
r Feed out the mat. Carefully peel the material from the mat and the joint parts from the material.
• Do not forcefully peel off the joint parts, it may damage your project.
• Depending on the material and the shape of the pattern, it may curl up after paper piercing.
Changing the Perforation Length
To prevent the material from moving or peeling off while paper piercing, there are uncut pieces as a joint part after cutting.
The appropriate length of the joint part may differ depend on the material and the paper piercing pattern. Change the “Perforation
Length” setting according to the paper piercing result.
Note
• This setting is only available when “Kit Activation (Paper Piercing)” is set to “ON”.
a Touch after selecting “Cut” in the preview screen.