Instruction Manual for Paper Piercing Starter Kit
Table Of Contents
- About the Paper Piercing Starter Kit
- Important Safety Instructions
- Precautions
- Accessories
- Activating the Paper Piercing Function on the Machine
- Activating Paper Piercing Patterns in CanvasWorkspace
- Preparing Paper Piercing Data in CanvasWorkspace
- Retrieving a Pattern From CanvasWorkspace to the Cutting Machine and Paper Piercing the Material
- Selecting a Built-In Pattern and Perform Paper Piercing
- Maintenance
- [Example] Creating a Project with Two Tools of Different Diameters
- TROUBLESHOOTING
- Error Messages
10
hSpecify a setting for “Offset Distance” to create an offset line inside or outside the pattern and then touch “OK”.
For this example, specify a setting of “-5.00 mm (-0.20”)” to create an offset line 5 mm (0.20”) inside the pattern outline.
• The original pattern line appears in green and the newly added offset line appears in black.
• After the offset distance has been specified, it cannot be edited.
• When you touch again after creating the offset line, another offset line will be created again.
a Created Offset line (The line which will convert to dot data)
i Select the pattern to be converted to dot data for paper piercing (hole punching), touch , and then select “ON” beside
“Dot Line”.
• The spacing between the holes to be punched can be specified with “Dot Spacing”.
The selected cutting data is converted to dot data.
j Install the auto blade holder (black) into the carriage.
• If the pattern will not be cut out, continue to step n to perform paper piercing.
k Select “Cut” in the preview screen.
A preview of the cutting lines appears.
1