Instruction Manual for Disney Vinyl Auto Blade Kit

9
d Specify the tiling settings.
a [File Name]:
Type in the name of the FCM file to be tiled.
b [Tiling Size]:
Select the tile (material) size.
If the roll feeder will be used, select [Rolled Material] (Available only when Roll Feeder is activated.).
If large data is split into many small tiles, the overall appearance may be compromised depending on the finished size or pattern.
Therefore, it is recommended to specify a larger tile size.
c [Overlap]:
Specify the overlap width for the tiles between 0.0 mm and 20.0 mm (0.0" and 0.79").
Gaps can easily form when joining together a tiled pattern with no overlap. Therefore, it is helpful to use the specified overlap width as
a margin or as a guide for joining the cutouts. Changing the setting changes the red lines in the tiled image preview box (5). Increasing
the setting increases the number of tiles and changes the tiling.
d [Weeding Box]:
To add weeding boxes to a tiled pattern, select the [Add Weeding Box] check box. To change the width of the spacing between the
weeding box and pattern, specify a [Spacing] setting between 0.0 mm and 20.0 mm (0.0" and 0.79"). Increasing the spacing between
the weeding box and pattern increases the number of tiles and changes the tiling.
e Tiled image preview box:
The tiling of the original pattern is indicated by red lines.
1
2
3
4
5
6