Instruction Manual for Disney Vinyl Auto Blade Kit

13
The following table lists some of the messages that may appear while the machine is operating as well as their corresponding
solutions. Perform the necessary operation according to the instructions in the message or the solution described here. If the problem
persists, contact Brother Customer Service or a Brother authorized service center.
Cutting Machine Error Messages
CanvasWorkspace Error Messages
Error Messages
Error Messages Cause/Solution
This holder cannot be used.
This message appears when the vinyl auto blade holder cannot be
recognized because the machine’s software has not been updated to
the latest version.
Update the software of the machine to the latest version. For details
on updating the machine, refer to the Operation Manual supplied with
it.
Error Messages Cause/Solution
The pattern is too large. Reduce the pattern size. (E10010)
This message appears when the pattern to be tiled exceeds the
maximum size (1498.6 mm (59") for the width or 1778 mm (70") for
the height). Reduce the size of the pattern, and then use the Tiling
function again.
The pattern is too large. Reduce the Overlap and the spacing of the
Weeding box.(E10103)
This message appears when the spacing between the overlap and
weeding box increases the size of the pattern, exceeding the
maximum allowable size. Perform one of the following.
- Reduce the setting for the overlap width. (page 9)
- Reduce the setting for the weeding box spacing. (page 9)
- If the overlap width and weeding box spacing cannot be changed,
reduce the size of the pattern.