User's Guide
Table Of Contents
- STORE OPERATIONS MANUAL
- Table of Contents
- SET UP
- DESIGINING A STAMP
- Overview
- Stampcreator P-touch Editor
- Tools for Formatting
- Formatting a Stamp
- Selecting the stamp size
- Typing text
- Changing the font
- Changing the character size
- Changing style effects
- Changing the font of a text block
- Changing the character size of a text block
- Centering text within a block
- Vertical and horizontal block alignment
- Drawing lines in a stamp
- Drawing a frame
- Changing the frame size
- Using special design frames
- Creating stamps with clip art images
- Creating stamps with pictures
- Advanced Steps
- Stampcreator Express
- MAKING A STAMP
- CARE & TROUBLESHOOTING
- SUPPLIES & ACCESSORIES
- SUPPORT NUMBERS
- brother ENG
2
SET UP
FCC Compliance
Federal Communications Commission (FCC) Supplier’s Declaration of Conformity (For USA Only)
Responsible Party:
Brother International Corporation
200 Crossing Boulevard
Bridgewater, NJ 08807-0911, U.S.A.
TEL: (908) 704-1700
declares that the product:
Product Name: Brother Stamp Creation System
“Stampcreator Pro”
Model Number: SC-2000USB
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Federal Communications Commission (FCC) Compliance Notice (For USA Only)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
General Precautions
• Be sure the machine is always placed on a level, stable surface.
• Keep the machine and its accessories out of direct sunlight and extremely dusty places. Dust and dirt can cause
distortion to the stamp image.
• Do not expose the machine, or any of its accessories, to extreme temperatures or high humidity.
• Do not try to disassemble the machine or any of its accessories.
• When connecting and disconnecting the cables, always be sure to grab the connectors, not the cords.
• Store the draft sheets, ID labels, and cleaning sheets in their packages.
• Do not use folded or damaged draft sheets, ID labels, or cleaning sheets.
• Do not look directly at the flash from the xenon lamp unit.
• Be careful that the CD ROM is not scratched.
• Do not put heavy objects on the CD ROM.
• Do not touch the printed draft sheet before creating a stamp.
• Do not remove the clear protective film before engraving a stamp.
• Do not reuse the ink pad as ink will have permeated the pad surface.
• Do not stand the stamp upside down immediately after it is assembled.
• Do not place the stamp on its side immediately after it is assembled.
• Do not touch the print heads.
• Do not use cleaning devices other than the print head cleaning pen and cleaning sheets supplied with the
Stampcreator Pro.
• Only lift the machine by grabbing the specified areas.
• Make sure that the power requirements specified for this machine are met.
• Do not touch the machine’s internal parts since they can become extremely hot after the machine has been used for a
long period of time.
• To prevent dust from entering the machine, do not leave the machine for a long period of time with the ink ribbon
compartment cover or stamp compartment cover open or the xenon lamp unit or draft sheet magazine tray uninstalled.
• Do not touch any of the machine’s internal sensors.