User's Guide
Table Of Contents
- STORE OPERATIONS MANUAL
- Table of Contents
- SET UP
- DESIGINING A STAMP
- Overview
- Stampcreator P-touch Editor
- Tools for Formatting
- Formatting a Stamp
- Selecting the stamp size
- Typing text
- Changing the font
- Changing the character size
- Changing style effects
- Changing the font of a text block
- Changing the character size of a text block
- Centering text within a block
- Vertical and horizontal block alignment
- Drawing lines in a stamp
- Drawing a frame
- Changing the frame size
- Using special design frames
- Creating stamps with clip art images
- Creating stamps with pictures
- Advanced Steps
- Stampcreator Express
- MAKING A STAMP
- CARE & TROUBLESHOOTING
- SUPPLIES & ACCESSORIES
- SUPPORT NUMBERS
- brother ENG
50
CARE & TROUBLESHOOTING
• The xenon lamp flashed, but the desired stamp could
not be engraved.
• Check that the cap was removed from the stamp
before it was inserted. (See page 40.)
• Check that there is no dust on the protective film
covering the surface of the stamp.
• Check that the clear plastic surface of the xenon lamp
unit is not dirty.
• Check that the printed draft sheet stopped over the
xenon lamp unit before trying to engrave a stamp.
• The lines in the layout are too thin, the text is too
small, or the fill pattern is too detailed.
• Replace the xenon lamp unit. (See page 45.)
• The stamp was engraved too much. • The layout is too detailed.
• The stamp was not engraved well enough. • Check that the clear plastic surface of the xenon lamp
unit is not dirty.
• Replace the xenon lamp unit. (See page 45.)
• Half of the stamp was either engraved too much or not
enough.
• Check that the stamp is inserted so that its surface lies
flat on the printed draft sheet before being engraved.
(See page 40.)
• The stamp is attached to the printed draft sheet. • Check that the protective film was not peeled off the
surface of the stamp before it was engraved.
• The draft sheet is not fed out after the stamp is
engraved (the xenon lamp flashed).
• Check that the draft sheet feeds out automatically the
next time that an ID label sheet or another draft sheet
is printed.
• The draft sheet or ID label sheet is jammed within the
unit or the error message “REMOVE LABEL 1”,
“REMOVE LABEL 2”, or “REMOVE LABEL 3” appears
in the LCD.
• Turn off the machine, and then remove the jammed
draft sheet or ID label sheet. (See page 46.)
PROBLEM SOLUTION