User's Guide
Table Of Contents
- STORE OPERATIONS MANUAL
- Table of Contents
- SET UP
- DESIGINING A STAMP
- Overview
- Stampcreator P-touch Editor
- Tools for Formatting
- Formatting a Stamp
- Selecting the stamp size
- Typing text
- Changing the font
- Changing the character size
- Changing style effects
- Changing the font of a text block
- Changing the character size of a text block
- Centering text within a block
- Vertical and horizontal block alignment
- Drawing lines in a stamp
- Drawing a frame
- Changing the frame size
- Using special design frames
- Creating stamps with clip art images
- Creating stamps with pictures
- Advanced Steps
- Stampcreator Express
- MAKING A STAMP
- CARE & TROUBLESHOOTING
- SUPPLIES & ACCESSORIES
- SUPPORT NUMBERS
- brother ENG
48
CARE & TROUBLESHOOTING
Refilling the Stamp Ink
If the stamp is faint or incomplete, use the ink bottle (sold separately) to refill the ink.
a Remove the holder from the stamp.
b Use the ink bottle to add five drops of ink to each refill hole in the stamp.
☞ NOTE: Be extremely careful when adding ink.
Do not use ink other than that specified,
otherwise the stamp may be damaged.
If too much ink is added, it may start leaking
from the stamp’s surface. In that case, make
a test stamp on scrap paper to remove any
excess ink.
c Put the holder back on the stamp.
☞ NOTE: Immediately after refilling the ink, keep the
stamp facing down until the ink begins to flow
from the stamp.
After refilling the ink, be sure to put the cap
back on the refill ink bottle.
Holder
Ink bottle
Refill holes