User's Guide
Table Of Contents
- STORE OPERATIONS MANUAL
- Table of Contents
- SET UP
- DESIGINING A STAMP
- Overview
- Stampcreator P-touch Editor
- Tools for Formatting
- Formatting a Stamp
- Selecting the stamp size
- Typing text
- Changing the font
- Changing the character size
- Changing style effects
- Changing the font of a text block
- Changing the character size of a text block
- Centering text within a block
- Vertical and horizontal block alignment
- Drawing lines in a stamp
- Drawing a frame
- Changing the frame size
- Using special design frames
- Creating stamps with clip art images
- Creating stamps with pictures
- Advanced Steps
- Stampcreator Express
- MAKING A STAMP
- CARE & TROUBLESHOOTING
- SUPPLIES & ACCESSORIES
- SUPPORT NUMBERS
- brother ENG
45
CARE & TROUBLESHOOTING
Cleaning the Print Heads
The print heads require cleaning whenever you change the ribbon cassette.
a Turn off the machine.
b Open the ink ribbon compartment cover.
c Pull back on the print head cover.
• The print heads are located on the thin gold-colored plate and are not
visible to the naked eye.
d Using a back-and-forth motion, use the print head cleaning pen (part
no. PRCLPEN) to clean along the print head.
☞ NOTE: Be careful not to touch the print head.
Keep the cap on the print head cleaning pen
when it is not being used.
e Release the print head cover and close the ink ribbon compartment
cover.
f Print again.
☞ NOTE: If the characters are still blurred, repeat the
above steps.
Replacing the xenon lamp unit
The xenon lamp has an approximate life of 2,000 flashes. The Stampcreator
Pro will automatically count the flashes. When the message “REPLACE Xe
UNIT” appears in the LCD, replace the xenon lamp unit even if the unit can
still flash.
a Press the Mode button on the machine until the message “RESET
COUNTER” appears in the LCD.
b Press the Set button to reset the xenon lamp counter.
c Slide the xenon lamp unit release lever up and pull out the xenon lamp
(part no. PRLAMP).
d Fully insert the new xenon lamp unit until it locks into place. Check
that “N = 0” appears in the LCD of the Stampcreator Pro.
e Press the Set button on the Stampcreator Pro.
☞ NOTE: Mark the used xenon lamp unit to identify the
old one from the new one.
Do not touch the print heads.
Do not use cleaning devices other than the
print head cleaning pen and cleaning sheets
supplied with the Stampcreator Pro.
Print head cover
Print head
Xenon lamp unit
release lever
Xenon lamp unit
compartment